Recording

Motion Recording

Use Motion Recording to have the system only record when motion is detected by one of the cameras. The camera that appears on-screen is the only camera that is recording.

REC

A

B

Figure 7.3 Recording triggered by motion during the Motion Recording

To enable Motion Recording:

1.Press Motion on the remote control or the RECORD—A button on the wireless receiver. A blue LED will light up beneath RECORD—A on the receiver.

2.Perform one of the following:

ƒEnable Quad Mode (recommended): Press the Quad button. When motion is detected, the system will display the triggered camera on-screen. When motion recording is complete, the view will return to Quad Mode.

ƒEnable Auto Sequence Viewing Mode: Press the CHANNEL—A button. When motion is detected, the system will display the triggered camera on-screen. When motion recording is over, Auto Sequence Viewing Mode will continue as normal.

ƒChange channels manually: Press the CHANNEL—M button on the wireless receiver or remote control to select a channel.

ATTENTION: If you manually select a channel while the system is in Motion Recording Mode, motion recording will ONLY apply to the selected channel. For example, with Motion Recording enabled, you manually select channel 3; if motion were to occur in view of camera 1, the system would NOT RECORD video from channel 1.

3.Press Motion on the remote control or the RECORD—A button on the wireless receiver again to stop Motion Recording. The blue LED will turn off on the receiver.

The “REC” indicator will only appear when motion is detected by one of the cameras on-screen.

By default, the system is set to record for 15 seconds after the triggered motion event. For details on adjusting the motion recording time, see “Trigger Record” on page 35.

25

Page 29
Image 29
LOREX Technology LW2301 instruction manual Motion Recording