Transducer Installation

Recommended Tools and Supplies

Tools and Supplies (not included)

If you plan to route the transducer cable through the transom, you will need either a 1” drill bit or a 5/8” drill bit depending on the size of the transducer cable connector. Each transom mount requires a high quality, marine grade above- or below-waterline sealant/adhesive compound. The following installations also call for these recommended tools and supplies.

One-piece Bracket Transom Installation

Tools: two adjustable wrenches or socket wrench, drill, #29 (0.136”) drill bit, screwdriver.

Supplies: none.

Two-piece Bracket Transom Installation

Tools: two adjustable wrenches or socket wrench, drill, #20 (0.161”) drill bit, screwdriver.

Supplies: four, 1” long, #12 stainless steel wood screws.

TMB-S Bracket Trolling Motor Installation

Tools: two adjustable wrenches or socket wrench, screwdriver. Supplies: plastic cable ties.

Skimmer Transducer Shoot-through Hull Installation

Supplies: alcohol wipes, 60 and 160 grit sandpaper, and marine grade above- or below- waterline epoxy adhesive.

Pod Transducer Shoot-through Hull Installation

Supplies: alcohol wipes, 60 and 160 grit sandpaper, and marine grade above- or below- waterline epoxy adhesive.

14