Pod Transducer Trolling Motor Installation
The top of the transducer is curved to fit the contour of the trolling motor.
You will need a hose clamp large enough to fit over the trolling motor. The hose clamp is NOT included with the Pod transducer.
Before you attach the transducer to the trolling motor, make sure there is enough slack in the transducer cable for the trolling motor to turn freely.
1:Slide the hose
clamp through the Pod transducer brackets, as shown below.
2:Slip the clamp around the trolling motor, as shown below. Tighten the hose clamp securely to
the trolling motor.
Note: The transducer should be mounted ahead of the trolling motor fin. Position the transducer to so its face is pointing straight down when the trolling motor is in the water.
Cable ties | Cable ties | |
Hose | Hose | |
clamp | ||
clamp | ||
|
Transducer
Route the transducer cable along the trolling motor shaft. Use plastic ties (not included) to secure the cable to the shaft.
27