Wiring the HDS
Wiring Guidelines
Most installation problems are caused by shortcuts taken with system cables. When wiring the HDS follow the guidelines below.
| Don’t do this | Do this |
|
|
Don’t make sharp bends in the cables | Do make drip and service loops |
|
|
Don’t run cables in a way that allows water | Do |
to flow down into the connectors |
|
|
|
Don’t route the data cables in areas adjacent | Do leave room at the back to install and |
to radar, transmitter, or large current | remove cables |
carrying cables |
|
Before starting the installation, be sure to turn electrical power off. If power is left on or turned on during the installation, fire, electrical shock, or other serious injury may occur. Be sure that the voltage of the power supply is compatible with the HDS display.
The HDS has a voltage rating of
The red wire should always be connected to (+) DC V using a fuse or thermal breaker (10 Amp)
29