TMB-S Trolling Motor Bracket Installation

Note: The TMB-S bracket is designed for one-piece bracket transducers only.

The TMB-S trolling motor bracket (Part No. 51-45) is an optional accessory and is available through LEI Extras at www.lei-extras.com.

The TMB-S bracket is used to attach a one-piece bracket transducer to a trolling motor. If you regularly fish in water with a lot of underwater structure, such as rocks, stumps and trees, you may consider using a Pod transducer for trolling motor installation. Pod transducers cannot be “kicked up” by underwater structure.

 

Internal tooth washer

Bolt

Plastic bracket

 

Lock nut

Flat washer

Using the components supplied with the TMB-S bracket (adjustable strap, internal tooth washer and plastic bracket) attach it to the transducer as shown in the diagram above.

Adjustable strap

Route the transducer cable

 

along the trolling motor

 

shaft. Use plastic ties (not

 

included) to secure the

 

cable to the shaft.

Slide the adjustable strap through the plastic bracket as shown above, left, then slip the strap around the trolling motor as shown in the image, at right. Position the transducer so its “face” is pointing straight down when the trolling motor is in the water. Tighten the adjustable strap securely to the trolling motor. Make sure there is enough slack in the transducer cable for the trolling motor to turn freely.

22