Skimmer Transducer Shoot-thru-hull Installation

Before attempting any installation on boats with flotation material sandwiched within the hull, consult the boat manufacturer. In a shoot-thru-hull installation the transducer is epoxied to the inside of the boat hull.

WARNING: Do not remove any material from the inner hull. Careless grinding or cutting on the hull could damage the integrity of the hull. Contact the boat dealer or manufacturer to confirm hull specifications.

 

Transducer

Transducer epoxied

Epoxy

 

to hull.

Hull

Note: The previous image shows a Skimmer transducer epoxied to a flat, solid portion of the boat hull near the transom. The circled image is a close-up view of the transducer epoxied to the hull.

On vee hulls try to place the transducer where the dead rise is 10° or less.

Note: While you can epoxy a Skimmer transducer to the inside of a boat hull, we recommend using a Pod transducer for this type of installation. Use care when mounting a transducer inside a boat hull. Once epoxied into position, the transducer can be very difficult to remove.

23