Lowrance electronic LVR-880 US NAV Show Waypoint, GO Reset the Cross Track Error, Man Overboard

2-11 NAV (Show Waypoint)

If a waypoint is already selected, the bearing and distance to the waypoint and the cross track error are shown on the bottom line of the LCD.

Hold down NAV to enter NAVIGATION mode and show these details:

To quit NAVIGATION mode, you must reset the radio. See Section 3-8.

If you are in NAVIGATION mode and want to scan all the VHF channels while staying in NAVI- GATION mode, just hold down SCAN. Press SCAN to quit scanning.

To select a favorite channel, use the 3CH key. See Section 2-16.

2-12 GO (Reset the Cross Track Error)

Press GO if you are navigating to a waypoint and want to reset the cross track error. This is a VERY useful single keystroke feature to use if you wander a little off-course but want to continue to your active waypoint.

The bearing and distance to the waypoint, and any cross track error, are shown on the bot- tom line of the LCD.

2-13 MOB (Man Overboard)

Man Overboard

Hold down MOB until the radio automatically enters NAVIGATION mode, saves your current latitude and longitude as the MOB waypoint and immediately sets this position as the desti- nation waypoint.

You will see the following sequence of LCDs:

HOLD 3 SEC	HOLD 2 SEC	HOLD 1 SEC	MOB
FOR MOB	FOR MOB	FOR MOB	B 010
RELEASE TO	RELEASE TO	RELEASE TO
			D 0.01
SAVE	SAVE	SAVE
			X 0.00

The bearing and distance to the Man Overboard position, and any cross track error (XTE), are

14 Lowrance - LVR-880 Operation Instructions