LSI 40909G-S Table 3.2 Error Messages (Cont.)

itmpt<n>: Could not allocate

memory to read conﬁguration data. The driver was unable to allocate memory required to process

the conﬁguration data. This means that the conﬁguration was

not properly determined. Toﬁx this you may need to manually

conﬁgure the driver using the itmpt.conf ﬁle.

itmpt<n>: Unable to make reset

notiﬁcation callbacks. The itmpt was unable to notify the target devicedriver of a bus

reset. The target driver may start to malfunction.

itmpt<n>:ddi_dma_unbind_handle:

failed Theoperating system failed to respond to the named routine in

a known manner. This is a fatalerror that is not recoverable.

Please report this error to technical support.

itmpt<n>: ddi_dma_numwin() failed. –

itmpt<n>: ddi_dma_getwin() failed. –

itmpt<n>: ddi_dma_alloc_handle:

xxh unknown/impossible. –

itmpt<n>:

ddi_dma_buf_bind_handle:

DDI_DMA_INUSE impossible.

–

itmpt<n>:

ddi_dma_buf_bind_handle: xxh

unknown/impossible.

–

itmpt<n>: No KeyROM found.

Hardware contains no valid license. Theadapter is not a valid LSI Logic/IntraServer adapter

licensed for use with Solaris.

itmpt<n>: Hi-level interrupts not

supported. The adapter is in a slot that cannot be used with this driver.

Please try moving the adapter to a different PCI slot.

itmpt<n>:Device in a slave-only slot

and is unusable. –

itmpt<n>: Failed to attach. This

adapter will not be installed. Because of one of the previous two errors, this adapter could

not be "attached" to the I/O subsystem and will not be

accessible. See the previous error message and solvethat

problem.

itmpt<n>: Unable to obtain soft

state structure. The driver wasunable to initialize a required data structure and

therefore did not load. Please call technical support.

itmpt<n>: Failed to attach interrupt

handler. The driver was unableto initialize the interrupt handler as

required. Please call technical support.

Table 3.2 Error Messages (Cont.)

Error Messages Explanation