Appendix A: Commands | SAS2 Integrated RAID Solution User Guide |
Sample Output Following is a sample of the information that the DISPLAY command returns.
Read configuration has been initiated for controller 0
Controller information
Controller type | : SAS2008 |
BIOS version | : 7.00.02.00 |
Firmware version | : 00.250.19.0 |
Channel description | : 1 Serial Attached |
SCSI | : 112 |
Initiator ID | |
Maximum physical devices | : 62 |
Concurrent commands supported | : 266 |
Slot | : 3 |
Segment | : 0 |
Bus | : 64 |
Device | : 1 |
Function | : 0 |
RAID Support | : Yes |
IR Volume information
Physical device information
Initiator at ID #112 |
|
Device at ID #335524 |
|
Device is a Hard disk | : 2 |
Enclosure # | |
Slot # | : 2 |
Connector ID | : 4 |
State | : Ready (RDY) |
Size (in MB)/(in sectors) | : 70007/143374738 |
Manufacturer | : HP |
Model Number | : DG072A9BB7 |
Firmware Revision | : HPD0 |
Serial No | : B365P720H7330709 |
Protocol | : SAS |
Drive Type | : SAS |
Enclosure information
Enclosure# | : 1 | |
Logical ID | : 51234567:89012345 | |
Numslots | : | 8 |
StartSlot | : | 0 |
Page 36 | LSI Corporation Confidential August 2010 |
