LSI SAS2 - page 22

Chapter 3: Creating Mirrored Volumes | Other Configuration Tasks SAS2 Integrated RAID Solution User Guide

Page 22 LSI Corporation Confidential | August 2010

Figure 7: Boot Device on SAS Topology Window

If a device is currently designated as the alternate boot device, the Device Info

column shows the word Alt.

3. To select the preferred boot disk, move the cursor to the disk, and press Alt+ B.

4. To remove the boot designator, move the cursor to the current boot disk, and press

Alt+ B.

This controller no longer has a disk designated as boot.

5. To change the boot disk, move the cursor to the new boot disk, and press Alt+ B.

The Boot designator moves to this disk.

6. To select an alternate boot disk, move the cursor to the disk, and press Alt+ A.

NOTE: To change the alternate boot device from one disk to another, follow steps 4

and5, but use Alt + A instead of Alt + B.

Contents

Main Revision History Version and D ate Description of Changes Table of Contents Page Chapter 1 1.1 Overview Introduction to the Integrated RAID Solution 1.2 Benefits and Features Chapter 2 2.1 Introduction 2.2 Integrated Mirroring and Integrated Mirroring Enhanced Features Overview of Integrated RAID Mirrored Volumes 2.3 Operation of Mirrored Volumes Figure 1: Typical Integrated Mirroring Implementation Figure 2: Integrated Mirroring Volume Figure 3: Integrated Mirroring Enhanced with Three Disks Figure 4: Integrated Mirroring + Striping with Four Disks 2.4 Mirrored Volume Features Page Chapter 3 3.1 Mirrored Volume Configuration Overview 3.2 Creating Mirrored Volumes Creating Mirrored Volumes Page Page Page 3.3 Managing Hot Spare Disks Page 3.4 Other Configuration Tasks Page Page Page Chapter 4 4.1 Introduction 4.2 Integrated Striping Features Overview of Integrated Striping 4.3 Integrated Striping Description Chapter 5 5.1 Integrated Striping Configuration Overview 5.2 Creating Integrated Striping Volumes Creating Integrated Striping Volumes Page 5.3 Other Configuration Tasks Page Page Page Appendix A A.1 Hardware and Software Requirements Using the SAS2 Integrated RAID Configuration Utility A.2 Interface Description A.3 Commands