Lucent Technologies USS-720 manual IOCTLSET1284REGISTER

USS-720	Preliminary User Guide, Rev. 2
USB Device Driver	February 1999

4 I/O Control Codes (continued)

4.19 IOCTL_SET_1284_REGISTER

IOCTL_SET_1284_REGISTER sets one of the 1284 registers. Details regarding parameters and error codes follow.

4.19.1 Parameters

lpInBuffer—Points to an input buffer that contains the following 2 bytes:

Byte	Description
0	Value to be written to the register.
1	Address of the parallel port register.

nInBufferSize—Specifies the size (in bytes) of the buffer pointed to by lpInBuffer. For this operation, this value should be 2.

lpOutBuffer—Points to an output buffer. Not used with this operation. Set to NULL.

nOutBufferSize—Specifies the size (in bytes) of the buffer pointed to by lpOutBuffer. Not used with this operation. Set to zero.

lpBytesReturned—Points to a DWORD that receives the actual size (in bytes) of the data stored into lpOutBuffer. Not used with this operation.

4.19.2 Notes

See USS-720USB-to-IEEE 1284 Bridge Preliminary Data Sheet, for more detail on the vendor-specific requests SET_1284_REGISTER.

4.19.3 Error Codes

ERROR_INVALID_ALTERNATESETTING—This command is only supported in ALT_INTERFACE_2 (see Section 4.9 of this document).

ERROR_INVALID_ADDRESS_REGISTER—Address of the parallel port register is read only.

STATUS_INSUFFICIENT_RESOURCES—Not enough memory to perform the request on this device instance.

7-28 Lucent Technologies Inc.