Lucent Technologies USS-720 manual Interrupts, Preliminary Data Sheet, Rev, Instant USB, September

Preliminary Data Sheet, Rev. 5	USS-720	Instant USB
September 1999	USB-to-IEEE	1284 Bridge

IEEE 1284 Port (continued)

Interrupts

The USS-720 can return interrupt status on the inter- rupt pipe. Interrupt status may be generated as a result of one of seven separately maskable conditions. Any interrupts that are pending will no longer be pending after a read operation. The individual conditions are described in the sections that follow.

nAck Interrupt

The nAck interrupt is enabled by setting the Interrupt Enable bit in the Control Register. An interrupt will be generated whenever nAck transitions from 0 to 1. Inter- rupt status is indicated by the nAck Interrupt bit in the Extended Control Register.

EPP Time-Out Interrupt

The EPP time-out interrupt is enabled by setting the EPP Time-Out Interrupt Mask bit in the Control Regis- ter to 0. Note that this is a change from typical host- side parallel port hardware, where interrupts on EPP time-out conditions are enabled by the Interrupt Enable bit in the Control Register.

An EPP time-out occurs when the peripheral fails to respond to an EPP handshake within the time allowed by the IEEE 1284 specification. If this occurs, there is no reliable way to determine whether the peripheral is still functioning or not, or whether the byte in transit was transferred properly, and it will be up to software to attempt to recover by resetting the connection or some other means.

nFault Interrupt

The nFault interrupt is enabled by setting the nFault Interrupt Mask bit in the USS-720 Control Register to 0. Interrupt status is reported via the nFault Interrupt bit in the Extended Control Register. The interrupt is gener- ated when in ECP Mode and either the nFault line tran- sitions from 1 to 0 or the nFault line is low and the interrupt is unmasked. This may indicate that the peripheral has reverse data to transmit.

Bulk In Interrupt

The Bulk In interrupt is enabled by setting the Bulk In Interrupt Mask bit in the USS-720 Control Register to 0.

Interrupt status is reported by the Bulk In Interrupt bit in the Extended Control Register, as well as the Bulk In Empty bit in the same register. This interrupt is gener- ated when there is Bulk In data available for reading by the host. By enabling this interrupt, the host may use the automatic polling of the interrupt pipe to receive notification of incoming data, rather than explicitly poll- ing the Bulk In pipe.

Bulk Out Interrupt

The Bulk Out interrupt is enabled by setting the Bulk Out Interrupt Mask bit in the USS-720 Control Register to 0. Bulk Out empty status is reported via the Bulk Out Empty bit in the Extended Control Register. This inter- rupt is generated when the Bulk Out data pipeline goes completely empty. By enabling this interrupt, the host may use the automatic polling of the interrupt pipe to be notified of the completion of a data transfer, rather than explicitly polling the Bulk Out Empty bit.

Change Interrupt

The Change interrupt is enabled by setting the Change Interrupt Mask bit in the USS-720 Control Register to 0. There is no Interrupt Status bit associated with the Change Interrupt. This interrupt is generated when any of the parallel port signal lines driven by the peripheral (nAck, Busy, nFault, PError, Select, or PLH) change state.

Disconnect Interrupt

The Disconnect interrupt is enabled by setting the Dis- connect Interrupt Mask bit in the USS-720 Control Register to 0. There is no Interrupt Status bit associ- ated with the Disconnect interrupt. This interrupt is generated when the Peripheral Logic High signal makes a transition from 1 to 0, or when Peripheral Logic High is 0 and all other parallel port signal lines driven by the peripheral (nAck, Busy, nFault, PError, and Select) are high for longer than one second. Either of these conditions should indicate that the peripheral has been disconnected from the USS-720.

Lucent Technologies Inc. 5-23