Installing your Lynx L-210 | Lynx instruction

3.Installing your Lynx L-210

1. Locate an optimum location for the Lynx L-210.

2.For connections to the Ethernet and DSL interfaces, please refer to the easy start guide.

3.Connect the AC Power Adapter. Depending upon the type of network, you may want to put the power supply on an uninterruptible supply. Only use the power adapter supplied with the Lynx L-210. A different adapter may damage the product.

Now that the hardware installation is complete, proceed to Chapter 4: Setting up your Lynx L-210

6

Image 6

Lynx manual Installing your Lynx L-210

Contents

Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Features Introduction Management Support Your gateway at a glance Ports and buttonsLED description Installing your Lynx L-210 Setting up your Lynx L-210 Log into your Lynx L-210Quick Start Setup for advance user Quick Start Local Area Network connection Configuring the WANWide Area Network connection New Connection PPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Configuring the LAN Modem setupModify an Existing Connection Enable/Disable Dhcp Changing the Lynx L-210 IP address Static IP address assignment Firewall/NAT Services Advanced for advance user onlyUPnP Port Forwarding Access Control Advanced Security Access Control LAN clientsMAC Address Filters MAC Multicast Static Routing Dynamic Routing System Commands Tools Update Firmware User ManagementPing Test Network Statistics StatusModem Test Connection Status Product Information Dhcp ClientsModem Status System Log Can’t connect to the Lynx L-210 Appendix a TroubleshootingLynx L-210 is not functional DSL Link LED continues to blink but does not go solid DSL Link LED is always off What is a firewall? Lynx L-210 terms