M&S Systems dmc1 manual Finish-Out Instructions, Installing the Room Station

dmc1

•Do not over-tighten the screws for the remote stations or the master as the plastic face panels may crack or strip out.

•Use only M&S Systems certified replacement parts and have them installed by an M&S Systems dealer or installer. Unauthorized substitutions can result in fire, electric shock, or other hazards.

•Upon completion of any service or product repair, have the M&S Systems dealer or installer conduct a safety check to ensure the system is in proper operating condition.

•Use only a damp cloth to clean the dmc1 master and room stations. Do not use liquid cleaners or aerosol cleaners.

Finish-Out Instructions

The finish-out installation should be made after the application of wall covering material.

Tools required:

•#2 Phillips screwdriver

•Standard flat head screwdriver

•Wire stripper/cutter

•Level

Installing the Room Station

Collect all the connectors included in the room station packages and place them in the wall housing for use later. At each room station location, strip approximately 4 inches of jacket

from the CAT5 wire and separate the colored

conductors from one another. Strip ½ inch ofFigure 1 - CAT5 wire insulation from each conductor as shown in figure 1.

www.mssystems.com 800.421.1587

Page 5