dmc1
Stereo/Mono Configuration
Each MC960PA remote amplifier is equipped with a stereo/mono select jumper. All MC960PA amplifiers are shipped
from the factory with this jumper in the STEREO position. If an amplifier is required to drive more than 10 monaural speakers, this jumper must be set to the MONO position (refer to figure 20).
Setting the jumper to the MONO position will |
|
cause monaural output to all speakers whether |
|
they are connected via stereo controls or mono |
|
controls. The jumper setting of one MC960PA |
|
amplifier has no effect on other MC960PA |
|
amplifiers. | Figure 20 – Jumper connections |
|
Other Sources
Plug in the RCA phono plugs to the jacks as marked for the source equipment. Figure 21 shows a typical installation using the AWP/AWPRX audio wall plate installation kit.
Figure 21 – AWP audio plate connections
www.mssystems.com 800.421.1587
Page 14