dmc1
may result in poor range of the wireless remote control system. Connect the wire harness from the MCRC to the connector labeled REMOTE on the master as shown in figure 10.
Door Release Connection
To use of the DRW door release, connect the VM127X cables from the remote power transformer and the DRW door release striker. The 24volt/4amp dry contact switch closure may also be used for home automation or security panel panic alarm interface. Note: The door release operation may only be used for one type of function per application.
Power Amp Finish-out
At each cable end, strip approximately 4 Inches of jacket (MS5XSC and MS2SXSC) from wires and separate colored wires from each other. Strip 1/2 Inch of insulation from each wire as shown in figure 1. On the MS7XSC, strip 1/4 Inch of insulation from each wire as shown in figure 2.
Figure 11 – MS5XSC/MS2SXSCWiring
Figure 12 – MS7XSC Wiring
Satellite Volume Controls
Connect the shield wire from outside shield of the MS5XSC to the MS2SXSC shield wires. DO NOT connect the shield wire for the brown/gray pair at this end of the cable! Wire nut each colored wire to its respective wire as shown in figures
Figure 15 – Volume control mounting
www.mssystems.com 800.421.1587 Page 11
