dmc1
Important: Verify all cable run locations prior to connecting if they were not labeled at
Install the optional chime module MC3 or MC8 in the wall housing by pressing the chime module over the 4 plastic standoffs attached to the wall housing as shown in figure 8. Refer to the instructions shipped with the chime module.
Suspend the master unit from the wall housing by looping the third hand wire (thick green wire) over the hook at the top of the housing. Be careful not to damage the wall surface.
Figure 8 - Chime module installation
See figure 9.
If the dmc1 system has more than 9 room stations, some room selector switches will control two room stations. Do not exceed more than 15 total speakers on the system. This limitation does not include remote controls, volume controls, speakers connected to the optional stereo power amp, of door stations. The station location can be noted on the inside of the front access panel on the left side of the
dmc1 master.
Connect the red and black wires of the door station cables
(MS4DCX/MS4DCXSC) to the red and black door speaker terminals on the dmc1 master as shown in figure 10. Insulate the bare wires using some of the jacket material to prevent shorting to the circuit board.
Connect this wire to terminal labeled shield. Connect all orange wires from the door stations to the common terminal on the MC3 or MC8.
www.mssystems.com 800.421.1587
Page 9
