M-Audio II User Guide 11MicroTrack II

User Guide 11MicroTrack II

< Channels:

  • Stereo: The Stereo option causes MicroTrack II to record both the left and right inputs into a stereo

ﬁle This is the default setting for MicroTrack II

  • Mono: This option causes MicroTrack II to record only the left channel of audio instead of both

< Link L+R Gain: This is a simple on/off menu selection When this option is set to on, the recording levels of

inputs L and R will be matched If you use the left or right [LEVEL] buttons to adjust the recording level of one

of the inputs, the other input will automatically be matched to the same level This is especially useful when

making stereo recordings as this setting will preserve the stereo image When this option is turned off, the

input levels of the channels will become independent

< Limiter: This option can be enabled (On) or bypassed (Off) When enabled, the analog input limiter prevents

digital distortion (clipping) in your recordings, which comes in handy when recording sources with a wide

dynamic range, such as drums or a gunshot The limiter will ensure that the initial attack (transient) of these

sounds does not exceed the headroom of MicroTrack II The analog limiter attenuates signal peaks above -

1dBFS before they are converted to digital This gives MicroTrack II greater gain-reduction capabilities than

the digital limiters found in other recorders Also, while not intended to replace proper input level settings, the

limiter can be helpful when recording with little or no time to set input levels If your recording levels are higher

than they should be, the limiter will ensure that you get a clip-free recording

This menu sets the automatic shutoff time for the MicroTrack II backlight Since the backlight drains more battery

power, you have the ability to automatically turn the light off to maximize your battery life

When set to “Always off,” the backlight will never turn on When “Always on” is selected, the back light will be on

whenever MicroTrack II is powered on The other three settings available on this menu determine the amount of

time the backlight will stay on after the last control is pressed on MicroTrack II For example, if “5 sec” is selected,

the backlight will turn on any time a button is pressed on MicroTrack II The back light will then turn off 5 seconds

after the last button is pressed

► NOTE: If the dimmer switch on the side of MicroTrack II is set to the Off position, the

backlight will never turn on no matter what setting is selected in this menu.

This setting adjusts the contrast of the MicroTrack II display Press up or down on the [NAV] wheel to adjust this

value Higher values result in a darker display Press in on the [NAV] wheel when ﬁnished