Majestic Appliances 360DVSL, 360DVSR Locating Your Fireplace, Clearance to Combustibles, Mantels

360DVS Series Direct Vent Fireplaces

Locating Your Fireplace

		X
		X	X
		B
	A	Y	A	Y
		Y	Z
				LU584-2
Fig. 3	Locating your gas fireplace

AWall Location (Fig. 3)

Y (Minimum distance between a glass panel and a

parallel wall) = 3’ (914mm)

V

W

X

Y

Z

A B C D E

Bottom of Door Trim

Fireplace

Louvre Assembly

Top

Top of Combustion

Chamber

CFM146

Z(Minimum distance between edge of a glass panel and an adjacent wall) = 3” (76mm)

BIsland Location (Fig. 3)

X (Maximum length of horizontal venting) = 20’ (6.1m)

Refer to the venting section in this manual for specific dimen- sions.

Clearance to Combustibles

Top of unit to ceiling	36” (914 mm)
Front of unit to combustibles	................... 36” (914 mm)
Appliance
Top	0” (0 mm) to standoff
Bottom	0” (0 mm)
Vent End	1/2” (13 mm) to rear panel
Nonvent End (DVS2)	0” (0 mm)

Venting
Concentric sections of DV Vent:
Top, bottom & sides	1” (25 mm)
Nonconcentric sections of DV Vent:
Side and bottom	1” (25 mm)
Top	2” (51 mm)

Mantels

The height at which a combustible mantel is fitted above the fireplace is dependent on the depth of the mantel. This also applies to the distance between the mantel leg (if so fitted) and the fireplace. For correct mounting height and width, refer to Fig. 4a and 4b and the Mantel Chart below.

The fitting of a bay window trim kit does not affect the distances and reference points referred to in the dia- gram and chart.

Noncombustible mantels and legs may be installed at any height and width around the appliance.

When using paint or lacquer to finish the mantel, such paint or lacquer must be heat resistant to prevent dis- coloration.

	Mantel Chart
	Mantel Shelf		Mantel from Top
Ref.	or Breast Plate	Ref.	of Comb. Chamber
V	10” (254 mm)	A	19” (483 mm)
W	8” (203 mm)	B	17” (432 mm)
X	6” (152 mm)	C	15” (381 mm)
Y	4” (102 mm)	D	13” (330 mm)
Z	2” (51 mm)	E	11” (297 mm)
Fig. 4a	Combustible mantel minimum installation.

Top View

	J	I H	G
Mantel Leg
				F

CFM197

Front View	LK
Side of Combustion	M
	N
Chamber	O

							Mantel
							Leg
							CFM170
			Mantel		Mantel Leg From Side
Ref.		Leg Depth		Ref.	of Comb. Opening
F	10” (254 mm)			K		11¹⁄₂” (292 mm)
G		8” (203 mm)		L		9¹⁄₂” (241 mm)
H		6” (152 mm)		M		7¹⁄₂” (191 mm)
I		4” (102 mm)		N		5¹⁄₂” (140 mm)
J		2” (51 mm)		O		3¹⁄₂” (89 mm)
Fig. 4b	Combustible mantel leg minimum installation.

10006326 9