Majestic Appliances 360DVSL Fuel Conversion Instructions, SIT Top Convertible Pilot, PSE Pilot

Fuel Conversion Instructions

To convert this appliance from gas type to another, fol- low these instructions. Before proceeding, turn control knob to “OFF” and turn gas supply OFF. Turn OFF any electricity that may be going to the appliance.

CAUTION: Logs may be HOT! Allow to cool before proceeding.

This conversion procedure must be carried out by an authorized service provider.

1.Disconnect power to unit and shut off the gas supply.

2.Remove window frame assembly (see “Window Frame Assembly Removal” Section).

3.Carefully remove the logs and lava rock material.

4.Remove the screws holding the burner housing as- sembly in place.

5.Remove the burner housing assembly. On some models you may need to loosen the pilot bracket retaining screw/nut, and tilt the pilot and bracket assembly to gain sufficient clearance to remove the burner housing assembly.

6.Remove front and rear orifice and replace with orifice supplied in the conversion kit.

NOTE: On 360DV/S2/S3/SL/SR, both burner orifices are the same size.

7.Remove the screws holding the air shutter to the burner tubes. (Fig. 47) Note the alignment of the air shutter on the tubes. Remove the air caps and re- place them with the new air shutters supplied in the conversion kit.

Air Shutter Retain-
ing Screws
Air Shutters	FP1447
Fig. 47 Air shutter adjustment.

8.SIT Top Convertible Pilot

Gently lift off pilot hood from the pilot. NOTE: Do not remove the spring clip holding the hood in place. Us- ing a correctly-sized Allen key, unscrew the exposed orifice. Insert the new orifice supplied in the kit; do not overtighten the orifice. Replace the pilot hood ensuring the index tab aligns with the notch on the hood.

360DVS Series Direct Vent Fireplaces

PSE Pilot

Using a suitable wrench on hexagonal body, un- screw the pilot hood assembly from the pilot. Do not twist the hood itself. Remove the orifice and replace it with the new orifice supplied in the kit. Refit the pi- lot hood assembly. Do not overtighten the pilot hood. The hood must return to its original alignment. Take care not to damage the thermocouple, thermopile or igniter.

9.SIT 820 NOVA Gas Control Valve (Fig. 48)

a)Using a Torx T20 or slotted screwdriver, remove and save three (3) pressure regulator mounting screws (A), pressure regulator tower (B), and dia- phragm (C).

b)Ensure the rubber gasket (D) is properly posi-

tioned and install the new HI/LO pressure regulator to the valve using the new screws (E) supplied with the kit. Tighten the screws securely. (Reference torque: 25 in.lb.)

c)Install the enclosed identification label (F) to the valve body where it can be easily seen.

A

B

C

	OFF
N		P
		L
		I
O	O
	T

FC107

Fig. 48 Remove mounting screws, pressure regulator tower and diaphragm assembly.

10006326 33