2.Connect the RED wire of the accessory cable to the POSITIVE (+) WIRE of your external speaker.
3.Be certain all wire connections are secure and that all open wires are adequately covered.
##NOTE: To extend the life of the radio, use waterproof tape to seal electrical connections.
Maintenance and Troubleshooting
Due to its rugged design, your radio requires very little maintenance. However, it is a precision electronic instrument, so you should follow a few precautions:
xx If the antenna has been damaged, you should not transmit except in the case of an emergency. A defective antenna may cause damage to your radio.
xx You are responsible for continued FCC technical compliance of your radio. xx
Problem | Things to Try | |
| Check the power connections. | |
The radio won’t power on. | Check the fuse. | |
Check the master battery switch and branch circuit | ||
| ||
| that connect to the radio. | |
| Make sure you are not in weather or scan mode. | |
| Make sure you are not trying to transmit on a receive- | |
| only channel (see the channels and frequency tables | |
The radio won’t transmit. | beginning on page 37). | |
Make sure you are transmitting at the correct power | ||
| level for this channel (see the channels and frequency | |
| tables beginning on page 37). | |
| Make sure the duration of each transmission is less | |
| than 5 minutes. | |
Noise comes out of the speaker | Adjust the squelch level; it is probably too low. | |
all the time |
| |
I can’t hear anything (no | Adjust the squelch level; it is probably too high. | |
volume) from the speaker. | ||
| ||
I can transmit, but no one can | Check your UIC channel settings (see Setting the UIC | |
hear me. | channel mode (USA/CAN/INT) on page 6). | |
The display flashes, and I don’t | The display will flash if the radio is in a watch mode or | |
in scan mode. Try turning off scanning, Weather Alert | ||
know why. | Watch, or Triple/Dual Watch (see page 6.) | |
| ||
I can’t read the display. | Adjust the contrast and backlight brightness level (see | |
page 16) | ||
| ||
The display is too bright at | Adjust the backlight brightness level. | |
Turn off the radio; hold | ||
night. | ||
back on (see page 16) | ||
|
34English
UM380_20101221.indd 34
4/13/2011 11:25:18 AM
