Makita EH7500S dimensions Spiral spring

Repair

P 15/ 25

[3]DISASSEMBLY/ASSEMBLY

[3]-7. Recoil Starter (cont.)

ASSEMBLING

Assemble the Recoil starter. (Figs. 28 and 29)

Fig. 28

Spiral spring

1. Set the outer end of Spiral spring here firstly and wind it clockwise till it is completely installed in the Starter case.

Note: Apply Makita grease N. No.2 a little on the Spiral spring (Red grease was applied to it at ex-factory condition).

2. Pass the new Starter rope through Starter case and	3. Fit the projection of Reel to the hook of Spiral spring
tie the both Rope ends in Starter knob and Reel.	while turning Reel clockwise.
And wind the Rope around Reel two or three times.	Projection of Reel

Starter case

Starter knob

Reel Hook of Spiral spring

Set screw Cam

Torsion spring

Note: Precisely fit the projection of Reel to the hook of

	Spiral spring by repeating the step 3.
4. Fix Torsion spring and Cam	5. Pull the slack rope in the Starter case
on the Reel with Set screw.	and hook it in the notch of Reel.
	Reel	Notch

Starter case

Mounted Reel

Fig. 29

Rope

6.Hold the rope near by the notch and turn it with the Reel clockwise to let Spiral spring have recoil force for driving Reel.

ReelNotch

7.Remove the rope from the notch and release your finger from Reel. The Reel turns counterclockwise. Repeat the actions of 5, 6, 7,

until the Rope is wound by the Reel completely.

Reel Rope

Rope