Manhattan Computer Products PLAZA HD-T2 B4

Ensure your television is turned off and connect the HDMI cable

supplied between the HDMI socket at the back of your Plaza HD•T2

receiver and an HDMI socket on your television. There may be more

than one HDMI socket on your television. If you are not sure which

to use, check the television’s manual.

Plug the power cable from the rear of the Plaza HD•T2 into an

available mains socket that is turned off.

You can also connect the Plaza HD•T2 receiver to a stereo or surround

sound system, so that you can listen to the TV sound through the

sound system instead of (or as well as) the television’s speakers.

If you connect a coaxial S/PDIF lead (not supplied) between the

S/PDIF sockets on your receiver and digital sound system, you can

listen to the TV sound in digital audio quality, or even in surround

sound, depending on the broadcast and your sound system.

To use apps such as BBC iPlayer or YouTube, the Plaza HD•T2 must

be connected to your internet router or hub using an ethernet cable

(not supplied). Plug one end of the ethernet cable into the ETHERNET

socket at the back of the Plaza HD•T2, and the other into your hub or

router. Make sure the connections are fully pushed in - you’ll hear a click

as they lock into place. Consult your router or hub’s documentation for

further guidance.

HINT: If your television has no HDMI socket, then it must

be connected to the receiver by SCART or RCA cable, and

you will not be able to watch Freeview channels in high

deﬁnition.

If your receiver is not located near your hub or router, you could use

HomePlug powerline adapters to extend your home network using

the ring main of your house. Another option is to use a Wireless

Ethernet Bridge to bridge the Ethernet socket of the Plaza HD•T2

to Wi-Fi, enabling it to connect wirelessly to your home network.

For more information, please consult with your installer or retailer.

If you require support for these devices, you will need to contact

the manufacturer. The Plaza HD•T2 does not support USB Wi-Fi

dongles.

Take off the battery compartment cover from the back of the

Plaza HD•T2 remote control by lifting it up while pushing the catch.

Insert the two AAA batteries supplied, as shown on the inside of

the compartment, and replace the compartment cover.