ENGLISH |
Introduction
Part Names and Functions
Front Panel
Introduction
Rear Panel
8 | 9 | 10 11 | 12 | 13 |
|
|
|
|
|
| 14 |
1 | 2 | 3 | 4 5 | 6 | 7 | 16 15 |
The unit can also be turned on by pressing the buttons with circled numbers.
1 | 6 | 9 | |
|
|
|
|
|
|
|
|
2 | 3 | 4 | 5 | 7 | 8 | 10 |
1.STANDBY indicator
This indicator lights up in green when the power is on, and lights up in red in standby mode.
2.ON/STANDBY button
Press to turn the unit to standby mode. In standby mode, this unit still consumes small amount of power.
3.ON / OFF (POWER) switch
Press to turn the unit on and off. If you turn off the unit using this switch, the unit does not consume power. In this condition, this unit does not accept any button except this switch.
4.VIDEO NR indicator
Indicates that video signals of a BD, DVD, etc., are being processed digitally with the DNR (Digital Noise Reduction) processing.
5.Infrared sensor window
Receives signals from your remote control so that you can control the unit from a distance.
6.Display
Refer to “Front Panel Display” on page 9.
7.SD CARD slot
Insert an SD Memory Card, and play back the contents in it.
8.Disc tray
Place a disc when opening the disc tray.
9.A OPEN/CLOSE button
Press to open or close the disc tray.
10.B PLAY button
Press to start or resume playback.
11.C STOP button
Press to stop playback.
12.H / G (SKIP DOWN/UP) button
Press to skip down/up titles/chapters/tracks/files.
13.h / g (FAST FORWARD/REVERSE) button
Press to search forward / backward through a disc.
14.F PAUSE button
Press to pause playback.
15.VIDEO NR (NOISE REDUCTION) button
Press repeatedly to reduce the overall level of noise on the picture (DNR). Each time you press the button, the level of the DNR switches “Off” A“+1” A“+2” A“+3” A“Off”.
16.HDMI (RESOLUTION) button
Press to set the HDMI jack’s video signal output mode.
1.DIGITAL OUT jack
Use digital audio coaxial/optical cable to connect to an AV receiver, Dolby Digital decoder or other device with a digital audio coaxial/optical input jack.
2.7.1ch AUDIO OUT jacks
Use an RCA audio cable to connect these jacks to the
3.2ch AUDIO OUT jacks
Use an RCA audio cable to connect these jacks to the
4.VIDEO OUT jack
Use an RCA video cable to connect to a TV monitor, AV receiver or other device.
5.S VIDEO OUT jack
Use an
6.HDMI OUT jack
Use an HDMI cable to connect to a display with an HDMI input jack.
7.COMPONENT VIDEO OUT jacks
Use a component video cable to connect to a display device with component input jacks.
8.REMOTE CONTROL OUT/ IN jacks
By connecting this
9.CONTROL CONNECTOR (RS-232C)
This is a terminal for future system extension.
10.AC IN Terminal
Use to connect the AC cord to supply the power.
Note
•Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the unit.
7
ENGLISH