,AMP button
The JOG control can be used in the TUNER, AMP or TIMER modes. Press to change the mode of JOG control to AMP mode. 5 seconds after the previous JOG operation is finished, the mode of JOG control will return to AMP mode automatically. You can also use this button to return to AMP mode immediately. The function of JOG control in AMP mode is changed as follows (except the volume adjust mode):
SOURCE select mode: To select input mode.
(Volume adjust mode: To adjust the volume level by turning the volume control.)
Balance control mode: To adjust the speaker balance. BASS control mode: Tone control (Low frequency)
TREBLE control mode: Tone control (High frequency)
The AMP mode is used for tone control (BASS/TREBLE) and to change also source for JOG control.
.TUNER button
Press to select FM or AM tuner when another source is selected and select the JOG operation for TUNER selection. Use this button to select the JOG operation for a scan of frequency or preset memory mode. The TUNER button changes modes as below.
FREQUENCY mode: To scan tuning by frequency by JOG control.
PRESET mode: To scan tunings in the preset memory by JOG control.
TUNER mode: To change FM broadcasting to MONO or
STEREO.
The “MONO” indicator lights up on the display in MONO position, the “AUTO” indicator lights up when there is no signal and “STEREO” lights up when a stereo signal is received.
Please refer to page 9 for tuner operations.
⁄0TIMER button
This button is used to program and check the timer program. Please refer to page 11 for timer program operation.
⁄1BAND button
This button is used to change the reception band to FM or AM.
⁄2MEMO button
This button is used to set the preset memory of the tuner or clock time.
Please refer to the tuner and timer operations.
⁄3WOW button
This button is used to change the WOW function level.
Each press of this button change the WOW function level following order.
OFF → LOW → HIGH → OFF
Note:
When this button is pressed, the sound of speakers is muted momentary. This is not malfunction.
⁄4VOLUME control
To increase or decrease sound level. To increase the sound level turn clockwise, and to decrease turn
⁄5PHONES jack
For connecting a pair of stereo headphones. When the headphones are connected to this jack, the speaker sound is turned off.
Note:
Door cannot be closed when headphones connected.
⁄6Display panel
This panel shows information on the status of the unit.
⁄7Infrared sensor
The infrared signal from the remote control enters the unit through this sensor.
ENGLISH
5
