PRESENT TIME SETTING
To operate the timer program, you must set the present time. The clock time can be set
The following shows as an example how to set the time as 2:30 PM.
The clock displays “0:00” at initial
Operation using the main unit
MEMO
DISPLAY
1.Press the DISPLAY button x until the clock time is displayed.
2.Press the MEMO button ⁄2. “12/24” is displayed.
3.Turn the JOG control m to select “12”.
When you select “24”, the clock is set
4.Press the JOG control m to desired the system. The hour digit blinks.
5.Turn the JOG control m to set the digits displayed to the left of the colon to “2:00 PM” and press the JOG control m. The minute digit blinks.
6.Turn the JOG control m to set the minutes to “30”, and press the JOG control m.
The display blinks.
7.Press the JOG control m to confirm the actual clock. The clock now starts.
Operation using the remote control
TIMER | TIMER |
1.Press the TIMER button !8more than 3 seconds. “12/24” is displayed.
2.Press the 4 ¢ button o !0to select “12”.
When you select “24”, the clock is set
3.Press the TIMER button !8to confirm the system.
The hour digit blinks.
TIMER | TIMER | TIMER |
4.Press the 4 ¢ button o !0to set the digits displayed to the left of the colon to “2:00 PM” and press the TIMER button !8.
The minute digit blinks.
5.Press the 4 ¢button o !0to set minutes to “30”, and press the TIMER button !8.
The display blinks.
6.Press the TIMER button !8to confirm the actual time. The clock now starts.
PROGRAMME TIMER SETTING
You can play marantz CD player CD110, when it is connected | ENGLISH | ||
with remote control bus correctly. | |||
| |||
The timer function is built into this receiver allows you to |
| ||
perform the following operations: |
| ||
• Setting of ON time and OFF time; |
| ||
• | Setting of source: The source can be selected from tuner, |
| |
| CD; |
| |
• | It is possible to specify the preset number 1 to 30 or track |
| |
| numbers of CD; |
| |
• | Setting of single operation (Once) or everyday operation |
| |
| (Everyday). |
|
IMPORTANT:
-The timer setting with track number specified can be used only when the system control switch is set to SYSTEM position except when only using the tuner. (Refer to page 6.)
In the following procedure, each button should be pressed within 5 seconds after pressing the previous button.
1.Press the power switch z to turn the power of the unit ON.
2.Press the TIMER button ⁄0. The display indicates “ON TM” and the timer section blinks.
3.Set the On time.
TIMER | TIMER |
TIMER
1Turn the JOG control m to adjust the hour for the On time and press the TIMER button ⁄0.
2Turn the JOG control m to adjust the minutes for the On time and press the TIMER button ⁄0.
The display indicates “OFF TM” and the timer section blinks.
4.Set the Off time.
TIMER | TIMER |
1Turn the JOG control m to adjust the hour for the Off time and press the TIMER button ⁄0.
2Turn the JOG control m to adjust the minutes for the Off time and press the TIMER button ⁄0.
“TimePLAY” is displayed.
5.Select a timer mode.
TIMER
1Select the “TimePLAY” by turning the JOG control m. The recording mode is unavailable for this version.
2Press the TIMER button ⁄0.
11