Setting the network [Network]

•For details on “Quick Setup” operations, see the separate “Getting Started”.

•If you cancelled “Quick Setup” menu or changed the network environment, perform “Menu” – “Quick Setup”.

Connecting wired LAN

Use this procedure to configure the wired LAN settings.

nnNetwork connecting(when “DHCP”settings are “On”)

When using this unit with the broadband router’s DHCP function enabled, this unit automatically performs the IP address setting and other settings.

1 Connect the LAN cable (vpage 8 “Connecting to a home network (LAN)” – “Wired LAN”).

2 Press X (on/standby) to turn on power to the main unit.

3 Press MENU.

Turns on the Menu settings mode and the Menu appears on the display (vpage 11 “Menu map”).

4 Use ui and ENTER to select “Network” – “Settings” – “DHCP (On)”, then press ENTER or p.

“Select DHCP” menu appears.

5 Use ui to select “On”, then press ENTER or p. “Setup Ethernet” menu appears.

6 Use ui to select “Test Connection”, then press ENTER or p.

“Wait for the network to connect...” is displayed, and the unit starts connecting to the LAN.

•When the connection is made successfully, “Connected!” appears.

•If the connection cannot be established, “Connection Failed” is displayed. Perform steps 1 – 6 again.

You may need to set the network connection manually, depending on the provider you use. To set the connection manually, use the setting procedure of “Network connecting (when “DHCP” settings are “Off”)”.

15

nnNetwork connecting

(when “DHCP” settings is “Off”)

This section explains the settings when connecting this unit to a network that does not have a DHCP function.

To configure the settings manually, check the setting details with your network administrator.

1 Perform steps 1 – 4 of the “Network connecting (when “DHCP” settings are “On”)” procedure and select “Off” in step 5.

“Setup Ethernet” menu appears.

2 Use ui to select “IP Address”, then press ENTER or p.

“Enter IP Address” menu appears.

3 Use uip or 0 – 9 to input the

IP address and press ENTER.

4 Use uip or 0 – 9 to input the address for “Subnet Mask”, “Gateway”, “Primary DNS”, and “Secondary DNS”.

5 Use ui to select “Test Connection”, then press ENTER or p.

“Wait for the network to connect...” is displayed, and the unit starts connecting to the LAN.

•When the connection is made successfully, “Connected!” appears.

•If the connection cannot be established, “Connection Failed” is displayed. Perform steps 1 – 5 again.

Preparation

Operation

Information