REAR PANEL
z x c v b n m , . ⁄0
ENGLISH
OPTPRE OUT MAIN IN
1 L
| MONI. | MODEL NO.SR9200 |
| 2 |
|
GND |
|
|
MULTI VIDEO | MONI. | Y |
OUT | 1 | |
ANTENNA |
|
|
–+
FRONT
LEFT
FRONT
–+
MULTI
ROOM
LEFT
MULTI
COAX
2
3
R
C
LD | CB | MONITOR |
OUT | ||
GND |
|
|
DVD | CR |
|
AM |
|
|
RIGHT
SURR.
BACK
LEFT
ROOM RIGHT
CENTER
RS232C
EXT. IR
OUT
DC OUT 1 DC OUT 2
IN 
OUT
MULTI
RC
4 SW
5
SL
6
SR
7
SBL
8SBR
MULTI
9OUT
|
| DSS | Y |
|
R | L |
| DSS |
|
|
|
| IN | VCR2/ |
FRONT | CD | TV | CB | |
|
|
|
| IN |
SURR. | IN | IN | CR |
|
|
| |||
| TAPE | VCR1 |
|
|
SURR. | OUT |
| Y |
|
BACK | OUT |
| ||
|
|
| DVD |
|
| IN |
| IN | VCR1 |
| IN | CB | ||
|
| IN | ||
|
|
|
| |
| VCR2/ |
|
| |
S.W | CENTER /MD |
|
| |
| OUT | OUT | CR |
|
SURR.
BACK
RIGHT
SWITCHED 120W 1A
UNSWITCHED 120W 1A
SURR.
LEFT
SURR.
RIGHT
SPEAKER SYSTEMS
R AUDIO L | R | L | VIDEO |
AC OUTLETS 120V 60HZ | AC IN |
¤0⁄9⁄8⁄7⁄6
⁄5 ⁄4 | ⁄3 |
⁄2 ⁄1
zDIGITAL INPUT (Dig.1 - 9) / OUTPUT
(coaxial, optical)
These are the digital audio inputs and outputs. There are 5 digital inputs with coaxial jacks, 4 with optical jacks.
The inputs accept digital audio signals from a compact disc, LD, DVD, or other digital source component.
For digital output, there is 1 coaxial output and 1 optical output.
The digital outputs can be connected to MD recorders, CD recorders, DAT decks, or other similar components.
xPreamp Outputs (L, R, SL, SR, SBL,
SBR, C)
When the jumper plugs that link the Amplifier Inputs with these outputs are removed, these jacks may be connected to an external power amplifier.
cSubwoofer Output
Connect this jack to the line level input of a powered subwoofer. If an external subwoofer amplifier is used, connect this jack to the subwoofer amplifier input. If you are using two subwoofers, either powered or with a 2 channel subwoofer amplifier, connect a “Y” connector to the subwoofer output jack and run one cable from it to each subwoofer amplifier.
vMain Amplifier Inputs
When the jumper plugs that link the Preamp Outputs with these inputs are removed, these jacks may be used to connect an external source to the internal amplifiers.
Notes:
•When connecting a equipment, remove the attached jumper plugs and store them carefully so as not to lose them.
•Only remove the jumper plugs when required. After you finish using an Main Amp Input jack, replace the jumper plug.
bFM antenna terminal (75 ohms)
Connect an external FM antenna with a coaxial cable, or a cable network FM source.
AM antenna and ground terminals
Connect the supplied AM loop antenna. Use the terminals marked “AM” and “GND”. The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best
nMultiroom Outputs (Audio L&R, Video)
These are the audio and video output jacks for the remote zone (Multi Room).
Connect these jacks to the optional audio power amplifiers or video display devices to view and listen to the source selected by the mulitroom system in a remote room.
mMONITOR OUT
There are 2 monitor outputs and each one includes both composite video and
9
