Marantz SR9300 Manual Preset Memory, Recalling a Preset Station, Checking the Preset Stations

3. Each time the tuner finds a station, scanning will pause and the station will be played for five seconds.

During this time, the following operations are possible.

1)The band can be changed by TUNER button .

2)The tuning mode can be changed by T-MODEbutton.

4.If no button is pressed during this period, the current station is memorized in location Preset 02

If you wish to skip the current station, rotate the GYRO TUNING dial during this period, this station is skipped and auto presetting continues.

5.Operation stops automatically when all 50 preset memory positions are filled or when auto scanning attains the highest endof all bands. If you desire to stop the auto preset memory at anytime, press the CLEAR button.

MANUAL PRESET MEMORY

2.4.3.

2.

(Using the SR9300)

1. Tune into the radio station you desire (Refer to the “MANUAL TUNING” or “AUTO TUNING” section).

2. Press the MEMO button on the front panel. “– –“ (preset number) starts blinking on the display.

3. Select the preset number by rotating the GYRO TUNING dial, while this is still blinking (approx. 5 seconds)

4. Press the MEMO button again to enter. The display stops blinking. The station is now stored in the specified preset memory location.

(Using the remote control unit)

1. Tune into the radio station you desire (Refer to the “MANUAL TUNING” or “AUTO TUNING” section).

2. Tap the MEMO on the remote unite. “– –“ (preset number)starts blinking on the display.

3. Enter the desired preset number by tapping ten keypad.

Note:

•When entering a single digit number (2 for example), either input “02” or just input “2” and wait for a few seconds.

RECALLING A PRESET STATION

2.1.

1.

1.

(Using the SR9300)

1. Press the F/P button to show the preset station on the display.

2. Select the desired preset station by turning GYRO TUNING knob on the front panel

(Using the remote control unit)

1. Tap the Preset^ or Presetv button to select the desired preset station, or input your desired preset channel with ten keypad on the remote.

CHECKING THE PRESET STATIONS

The preset broadcast stations can be checked on the on screen	ENGLISH
display.

Press M button, “Tuner Preset Stations” screen appears on the on screen display.

Note:

• The device of remote control units need to be Tuner.

PRESET SCAN

	3.
	1. 3.	3.
(Using the remote control unit)
1.	Tap the Pre scan on LCD of remote control unit.
	“PRESET SCAN” appears on the display and then the preset
2.	station with the lowest preset number is recalled first.
	Preset stations are recalled in sequence (No.1 → No.2 → etc.) for
	5 seconds each.
3.	No stored preset number will be skipped.
	You can fast forward the preset stations by tapping the Preset^

continuously.

When the desired preset station is received, cancel the preset scan operation by tapping the CLR or Pre scan.

CLEARING STORED PRESET STATIONS

You can remove preset stations from memory using the following procedure.

3. 2.

2. 3.

1. Recall the preset number to be cleared with the method described in “Recalling” a preset station.

2. Press the MEMO button on the front panel or tap Memo on the remote.

3. Stored preset number blinks in the display for 5 seconds. While blinking, press the CLEAR button on the front panel or tap CLR on the remote unit.

4. “xx CLEAR” appears on the display to indicate that the specified preset number has been cleared.

Notes:

•To clear stored all preset stations, press and hold the CLEAR and the F/P buttons for two seconds.

47