Preparing the Remote Controller
1.Open the cover.
2.Insert batteries (AA).
Make sure to match the + and – marks on the batteries with inside the battery compartment.
INTRODUCTION
– Do not mix different battery types. | ENGLISH |
CAUTION |
|
– The available battery types are limited: manganese dry |
|
cell and alkaline dry cell. |
|
– Do not mix old and new batteries. |
|
– Only batteries of the same type are to be used. |
|
| |
– Remove exhausted batteries from the Remote |
|
Controller. |
|
– Do not attempt to recharge |
|
– Do not use rechargeable batteries. |
|
– Batteries are to be inserted with the correct polarity. |
|
– The supply terminals are not to be |
|
– Never throw batteries in a fire or attempt to open up its |
|
outer casing. |
|
– If the user does not intend to use the Remote Controller |
|
for a long time, remove the batteries. |
|
– Keep away from heat. |
|
– The effect range of the Remote Controller is approximately |
|
6m. |
|
– Do not be subjected to strong shock. |
|
– Do not be subjected to moisture. |
|
If the unit gets moistured, wipe it off immediately. |
|
– The Remote Controller operation may not function if the |
|
projector’s IR sensors are exposed to direct sun light or |
|
strong artificial light, or if there is an obstacle between |
|
the IR sensors and the Remote Controller. |
|
3.Close the cover.
7
