Features, Optics, Electronics & Software

INTRODUCTION

FEATURES

•Texas Instruments Digital Light Processing Technology

•High Definition Panel (1280 x 720), DMDTM HD

•16 : 9 Aspect Ratio

•Newly developed custom optics by Minolta

•1200 : 1 Contrast Ratio

•700 ANSI Lumens Brightness

•Brightness Uniformity : 90 %

•No Halo Effect

•Lens Up/Down Shift construction

•Short Throw Distance: 80"-8.6ft (2.6m), 100"-10.9ft (3.3m)

•Dust Free optics Sealing

•No Light Leakage (Double Seals Cabinet Structure)

•Extremely Quite (Noise Cancel Duct Construction, Ceiling Color Wheel Motor)

•Long Life Lamp (Average 2000 Hours)

•Double Shrink Seal Lamp Structure minimizes Burst Ratio

•Full Digital device

•3 Faroudja Chips Inside (Decoder, Doubler, and Enhancer)

•3-2 pull down

•10-Bit Digital Gamma Processing

•Horizontal Keystone Correction

•480p, 720p,1080i adapted

•IEEE 1394 DV Format adapted for Digital Video Camera Playback

•PC Signal VGA to XGA

•Three Picture Modes: Theater, Standard, Dynamic

•Nine Picture memories

•4 Aspect Modes

•Three Color Temperatures

•Black Level Selection

•Control through RS232C

•Two trigger for powered Screen Control

•Ecology Lamp mode

–DLP, Digital Micromirror Device and DMD are trademarks of Texas Instruments.

–“DCDi” is a trademark of Faroudja, a division of Sage Inc.

–“i.LINK” and the “i.LINK” Logo are trademarks.

–Even if no trademarks are indicated, they are greatly valued.

Note: Pixel defects	Note: Lamp
DMDTM (Digital Micromirror DeviceTM) is one of the most	SHP lamp is one of the most advanced technologies for
advanced technologies for consumer products. The	consumer products. The lamp made by high precision
DMDTM made by high precision technology, however some	technology, however some lamps might be failing before it
pixel defects may be found on the projected image. We	reaches its life. And projector’s brightness is getting
are trying our best to control the quality in order to reduce	darker along with accumulated lamp usage hours. We are
the number of defective pixels. It is almost impossible to	trying our best to control the quality in order to reduce
have zero pixel defects, even using the most advanced	lamp failures. It is almost impossible to have zero failure,
technology. This is not a problem only for Marantz, but all	even using the most advanced technology. This is not a
DLPTM projector manufactures. Therefore we have to note	problem only for Marantz, but all projector manufactures.
that the warranty does not cover the DMDTM for pixel	Therefore we have to note that the warranty does not
defects. We appreciate your understandings.	cover the SHP lamp for lamp failures: explosion, and non-
	lighting except initial use. And also we have to note that
	the warranty does not cover the SHP lamp for lamp
	failures: flickering, and getting darker along with
	accumulated lamp usage hours. We appreciate your
	understandings.