Problem

 

Check

Page

 

 

 

 

Picture is too bright and

•

Image adjustments are incorrectly set.

43

whitish.

 

 

 

The black levels of the

•

Select the HDMI Setting (“Normal” or “Expand”) that results in the

48

image show banding or

 

best picture quality.

 

appear faded when

 

 

 

HDMI is selected.

 

 

 

 

 

 

 

The cooling fan becomes

•

When temperature inside the projector increases, the cooling fan

–

noisy.

 

runs faster.

 

The lamp does not light

•

The lamp indicator is illuminating in red.

52, 55

up even after the

 

Replace the lamp.

 

projector turns on.

 

 

 

 

 

 

 

The lamp suddenly turns

 

 

 

off during projection.

 

 

 

 

 

 

 

The image sometimes

•

Cables incorrectly connected to the projector or the connected

23-27

flickers.

 

equipment works improperly.

 

 

•

If this happens frequently, replace the lamp.

55

 

 

 

 

The lamp needs much

•

The lamp will eventually need to be changed.

55

time to turn on.

 

While the remaining lamp life draws to a close, replace the lamp.

 

Picture is dark.

 

 

 

The remote control

•

Operate the remote control while pointing it at the projector’s remote

 

cannot be used.

 

control sensor.

 

 

• The remote control may be too far away from the projector.

15

 

• If direct sunlight or a strong fluorescent light is shining on the

 

 

 

 

projector’s remote control sensor, place the projector where it will not

 

 

 

be affected by strong light.

 

 

 

 

 

• The batteries may be depleted or inserted incorrectly. Make sure the

14

 

 

batteries are inserted correctly or insert new ones.

 

 

 

 

 

 

 

This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.

Appendix

61