Marmitek XS user manual Usage, Installation Of The Optional Ir Extender Cable Ir Eye

5. USAGE

1.Make sure that the A/V equipment is switched on.

2.Point your remote control at the Powermid XS IR receiver. The IR receiver receives the infrared signal, transforms it into an RF signal and transmits it to the Powermid XS IR Transmitter. The IR Transmitter then transforms this signal again into an infrared signal, which is transmitted to your DVD-player, decoder, video, stereo-equipment, etc. When you want to operate your equipment from several rooms, you can make use of several additional IR receivers (Art. no. 09773).

6.INSTALLATION OF THE OPTIONAL IR EXTENDER CABLE (IR EYE)

When you can’t place the IR transmitter within the sight of your A/V equip- ment (because it is in a closed cupboard, for example), then you can place the IR transmitter next to or on your A/V equipment with the use of an additional IR Eye (Art. no. 09682).

1.Connect the IR extender cable to the output [F] at the backside of the IR transmitter (see figure 1).

2.Remove the protection foil from one of the IR LEDs. Place this IR LED on the IR window of the A/V equipment that you want to operate. Don’t press it down too much yet. It is recommended that you check the function of the IR LED before its definite attachment. Point your original remote control at the sensor on the front side of the IR receiver, and choose a few channels, for example. When the A/V equipment does not respond, it may be so that the IR LED has not been attached at the right position. In case of some devices, the positioning is critical. You can use the second IR LED to operate a second A/V device. Never remove the IR LED, even if you don’t use it!

7. FREQUENTLY ASKED QUESTIONS

I can’t operate the A/V equipment via the Powermid XS. Consider the following instructions:

•Use strictly new (full) non-rechargeable alkaline AAA type batteries for your IR receiver.

•Check if the light of the IR receiver lights up when you use the remote control.

POWERMID XS™