MartinLogan manual AC Power Connections, Exos E2.5 IEC power cord AC receptacle

AC POWER CONNECTIONS

Because your MartinLogan Statement e2 ESL/Transition towers use an internal power supply to energize their elec- trostatic cells with high-voltage DC, they must be connected to an AC power source. The EXOS crossover must also be connected to an AC power source. For this reason the prop- er IEC standard power cords are provided. These cords should be firmly inserted into the AC power receptacles on the rear connection panel of the speakers and the EXOS, then to any convenient AC wall outlet. The ESL/Transition towers integrate a signal sensing power supply which will switch off after a few minutes of no music signal, and requires less than two seconds to recharge the panels when a music signal is present.

WARNING! Turn all amplifiers off when plugging in or unplugging the EXOS.

Your Statement e2 speakers and EXOS crossover are wired for the power service supplied in the country of original con- sumer sale. The AC power rating applicable to a particular unit is specified both on the packing carton and on the serial number plate attached to the speaker.

If you remove your Statement e2 speakers and EXOS crossover from the country of original sale, be certain that AC power supplied in any subsequent location is suit- able before connecting and operating the speakers. Substantially impaired performance or severe damage may occur to a speaker if operation is attempted from an incor- rect AC power source.

WARNING! The power cord should not be installed, removed, or left detached from the speaker while the other end is connected to an AC power source.

Figure 62. EXOS E2.5 IEC power cord AC receptacle. Figure 63. Statement E2 IEC power cord AC receptacle.

28 AC Power Connections