MartinLogan E2 manual Subwoofer Tower Assembly

ASSEMBLY

Subwoofer Tower Assembly

WARNING! Assembling the Statement e2 requires two people, except for step 12 of the subwoofer tower assembly, which requires three people. Do not attempt any part of the assembly process with one person.

1Place the primary subwoofer module in position on the floor, (the primary module has 10 binding posts). Corner placement is recommended—it is important to place the sub towers as close to final position as possible, as the final assembled tower weighs approximately 500 lb. However, for assembly you must leave enough space to have access to all sides of the sub tower. Place a level in position as shown to level the module left to right. Adjust the glider pads on the bottom of the cabinet to achieve level.

2Position the level as shown to level the primary mod- ule front to back, adjusting the glider pads on the bottom of the cabinet to achieve level.

3Pick up a secondary module with an assembler on each end and place carefully onto the primary module by lining up the cone feet on the secondary with the indentations at each corner of the primary module. Use your index finger as shown to feel when the cone feet are in position.

Figure 2

Figure 3

Figure 4

Assembly 5