3 Reassembly instructions
3.1.Attention when
·Please execute writing BIOS ID when you exchange the Main Board.
·Parts (Sheet and rubber) etc. related various the Conductive Cloth and Heat Spreader cannot be recycled. Use new parts.
3.2.Assembly knowhow of part LCD
LCD Rubber, LCD side Rubber and LCD backing Rubber’s putting
| LCD Rubber (Upper |
|
big | small LCD Front Case | LCD parallel after putting |
LCD Rubber (Upper)
LCD Side Rubber
LCD Back Rubber (Lower)
LCD Front Case
LCD Cable processing
Clamping processing of LCD Cable, LCD Connector connection and putting of PET Tape of cable The LCD Insulation Sheet is peeled off and after processes as shown in the figure below,
Put the Insulation Sheet. | 1 2mm |
|
PET Tape
LCD Insulation Sheet
1
2mm
Connector
LCD Frame Clamp
A red line of the cable is matched to the LCD Frame externals. | 1mm |
| ||
| 0 |
| ||
Putting of The Conductive Cloth |
|
|
| |
The Conductive Cloth is put and after putting, a both side tape is put. | Insulation seat of edge match | |||
Process the part in the signal line of the LCD Cable in the Conductive Cloth. | ||||
0 | 1mm | |||
Put the Conductive Cloth on the connector surely. |
|
| Conductive Cloth | |
|
|
| ||
|
|
| (LCD Label) | |
Connector of externals match | Connector |
|
| |
There must not be beginning to see from externals. |
|
| ||
|
|
| ||
| Both Side Tape |
| LCD Cable | |
LCD Insulation Seat |
|
| ||
