MaxTech PCI Internal Voice/FAX/Data/Speakerphone Modem user manual Fax Class 1 Commands

		Default is 5
\N_	\N0	Normal data-link only
	\N1	Normal data-link only
	\N2	MNP data link only
	\N3	V.42/MNP/Normal data link
	\N4	V.42 data link only
\O		Initiate reliable link during a normal link
\Q_	\Q0	Turn off flow control
	\Q1	XON/XOFF software flow control
	\Q2	CTS signal unidirectional hardware flow
		control
	\Q3	RTS/CTS signal bi-directional
		hardware flow	control
\Tn		Inactivity timer, where n = 0 to 90 minutes.
		Default is 0
\U		Accept reliable link during a normal link
\X_	\X0	Process XON/XOFF but don’t pass
		through
	\X1	Process XON/XOFF and pass through
\Y		Switch to reliable link from normal link
\Z		End the reliable connection and switch to
		normal operation
-J	-J0	Disable error control detection phase
	-J1	Enable error	control detection
		phase
"H	"H0	V.42bis data compression disabled
	"H1	Can send but not receive V.42bis data
		compression
	"H2	Can receive but not send V.42bis data
		compression
	"H3	Bidirectional	V.42bis	data
		compression enabled
"On		Set maximum V.42bis data block size to
		n (n=6-250). Default is 32

3.6Fax Class 1 Commands

+FAE=n	Data/Fax auto answer enable. Default is
	0
+FCLASS=1	Sets FAX operating mode
+FRH=n	Receive HDLC data
+FRM=n	Receive data
+FRS=n	Wait for silence

12