Installation

3.6.1.1Connecting the Adapter Board and the Drive

Use a 40-pin cable to connect the drive to the board. See figure 3-10.

To connect the drive to the board:

1.Insert the 40-pin cable connector into the mating connector of the adapter board. Make sure that pin 1 of the connector matches with pin 1 on the cable.

2.Insert the other end of the cable into the header on the drive. When inserting this end of the cable, make sure that pin 1 of the cable connects to pin 1 of the drive connector.

3.Secure the drive to the system chassis by using the mounting screws.

Figure 3-10Drive Power Supply and ATA Bus Interface Cables

Maxtor DiamondMax 17 80-160GB AT Hard Disk Drive

3-15

Page 30
Image 30
Maxtor 80-160GB manual Connecting the Adapter Board and the Drive