DIAMONDMAX PLUS 5120 PRODUCT MANUAL
Ultra Direct Memory Access (UDMA) | 4 | - 5 |
OS Requirements for Large Capacity Hard Drives | 4 | - 5 |
Hard Drive Identification | 4 - 6 | |
Identifying IDE Devices on the Interface | 4 | - 6 |
Jumper Settings | 4 | - 6 |
Systems Using Cable Select | 4 | - 6 |
Relationship to Other IDE Devices | 4 | - 6 |
Mounting Drive in System | 4 | - 7 |
Attaching Interface and Power Cables | 4 - 7 | |
Attaching System Cables | 4 | - 7 |
System Setup | 4 | - 8 |
Setting the BIOS (CMOS) | 4 | - 8 |
BIOS (CMOS) Parameters | 4 - 8 | |
Hard Drive Preparation | 4 | - 10 |
System Hangs During Boot | 4 | - 12 |
Section 5 — AT Interface Description
Interface Connector | 5 - 1 |
Pin Description Summary | 5 - 1 |
Pin Description Table | 5 - 2 |
PIO Timing | 5 - 3 |
DMA Timing | 5 - 4 |
Ultra DMA Timing Parameters | 5 - 5 |
Section 6 — Host Software Interface
Task File Registers |
| 6 - 1 |
Data Register |
| 6 - 1 |
Error Register |
| 6 - 1 |
Features Register | 6 - 1 | |
Sector Count Register | 6 - 2 | |
Sector Number Register | 6 - 2 | |
Cylinder Number Registers | 6 - 2 | |
Device/Head Register | 6 - 2 | |
Status Register |
| 6 - 2 |
Command Register |
| 6 - 3 |
Read Commands | 6 - 3 | |
Write Commands | 6 - 3 | |
Mode Set/Check Commands | 6 - 3 | |
Power Mode Commands | 6 - 3 | |
Initialization Commands | 6 - 3 | |
Seek, Format, and Diagnostic Commands | 6 - 3 | |
S.M.A.R.T. Commands | 6 - 3 | |
Summary |
| 6 - 4 |
Control Diagnostic | Registers | 6 - 5 |
Alternate Status | Register | 6 - 5 |
iii
