INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Tools needed
■ | Level | ■ | |
■ | Utility knife | ■ | Pliers |
■ | Scissors | ■ | Bucket |
■200 mm (8") or 250 mm (10") adjustable wrench
Parts supplied
Remove parts bag from washer. Check that all parts were included.
■ | 1 | Hose clamp | ■ | 2 | |
■ | 2 | Inlet hoses |
| with nuts | |
■ | 4 | Flat water hose washers | ■ | 1 | Drain hose |
|
|
| ■ | Hose adapter | |
Technical |
| Clothes | |
Specifications: |
| Capacity: | |
|
|
|
|
220 | – 240 V, 50 Hz. AC |
| MAT14CS: 5.9 Kg Max. |
|
|
|
|
650 | Watts |
| MAT15MN: 8.2 Kg Max. |
|
|
|
|
Location Requirements
IMPORTANT: Do not install or store the washer where it will be exposed to the weather. Do not store or operate the washer in temperatures at or below 0°C (32°F). Some water can remain in the washer and can cause damage in low temperatures.
Proper installation is your responsibility.
You will need:
■A water heater set to deliver 60°C (140°F) water to the washer.
■An earthed electrical outlet located within 1.2 m (4 ft) of where the power cord is attached to the back of the washer.
See “Electrical Requirements.”
■Hot and cold water taps located within 1.2 m (4 ft) of the back of the washer, and provide water pressure of
■A level floor with a maximum slope of 25 mm (1") under entire washer.
■A sturdy floor to support the washer weight (washer, water, and load) of 143 kgs (315 lbs).
Recessed Area and Closet Installation Instructions
This washer may be installed in a recessed area or closet.
The installation spacing is in inches and is the minimum allowable. Additional spacing should be considered for ease of installation, servicing, and compliance with local codes and ordinances.
If closet door is installed, the minimum unobstructed air openings in the top and bottom are required. Louvered doors with equivalent air openings are acceptable.
|
| Closet door |
| 3.10 m2 | 356 mm |
| (48 in2)* | (14") max. |
432 mm |
|
|
(17") |
|
|
| 1.55 m2 | 102 mm |
| (4") min. | |
| (24 in2)* |
|
0 mm | 0 mm | 25 mm (1") |
(0") | (0") | min. |
Recessed front view | Closet side view |
| 76 mm (3") |
3.10 m2 |
|
(48 in2)* |
|
Front view | closet |
| door |
1.55 m2 |
|
(24 in2)* |
|
| 76 mm (3") |
*Opening is the minimum for a closet door.
Louvered doors with equivalent air openings are acceptable.
■Additional spacing should be considered for the ease of installation and servicing.
■Additional clearances may be required for wall, door, and floor mouldings.
■Additional spacing of 25 mm (1") on all sides of the washer is recommended to reduce noise transfer.
■Companion spacing should also be considered.
4
