Maytag MAT14CS, MAT15MN Electrical Requirements, Product Dimensions, Standpipe Drain System

Product Dimensions

H

I

D	K
	Cold
	Hot

A G

B

C

E

F
M	L
N

A.	1.09 m (43")	I.	Power supply cord
B.	970 mm (381⁄8")	J.	Drain hose connector
C.	890 mm (35")	K.	Label
D.	38 mm (11⁄2")	L.	685 mm (27")
E.	705 mm (27 3⁄4")	M.	133 mm (51⁄4")
F.	650 mm (251⁄2")	N.	25 mm (1")
G.	Water inlets	O.	Water level switch and shaft
H.	180 mm (7")	P.	127 mm (5")

Drain System

Standpipe Drain System

The standpipe drain requires a minimum diameter standpipe of 50 mm (2"). The minimum carry-away capacity can be no less than 64 L (17 gal.) per minute.

The top of the standpipe must be at least 990 mm (39") high and no higher than 1.83 m (72") from the bottom of the washer.

Electrical Requirements

■A 220-240 volt, 50 Hz., AC only, 10-amp, fused electric supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided.

■This washer is equipped with a power supply cord having an earthing plug. The plug should be accessible for disconnection from the supply.

■If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified . . . . . . . .

persons in order to avoid a hazard.

Using the universal cord included with this washer:

This washer is equipped with a universal cord with interchangeable mains plugs.

1.Select the appropriate mains plug assembly from those supplied and attach it to the mains cord connector.

2.Snap the 2 halves of the cord lock together over the connector to retain it in position.

5