Problem | Cause | Solving the problem |
| shock absorbers are cold | • change the shock absorbers |
|
|
|
Door fails to open | • a fault is occurred | • wait until the counter has reached ‘0’ |
| • power is off, safety is working | • wait until safety device is inactive |
| • power is off, after a couple of | • you can always open the door by the |
| minutes waiting the door is jammed | mechanical override, be sure the machine |
|
| is stopped spinning and there is no hot |
|
| water anymore in the tub. |
|
|
|
Machine will not spin | • a fault in the program is made | • check the program |
| • wiring is damaged | • check and replace wiring |
| • | • replace the |
| • Motor is broken | • repair or change motor |
| • Frequency converter is damaged | • repair or replace the frequency |
|
| converter |
|
|
|
There is a lack of steam | • leak in steam system | • repair the leakage |
| • too many condense in the steam | • Remove the condens |
| system | • Disconnect other machines or increase |
| • too much machines on 1 supply | |
| steam capacity | |
|
|
|
6.3. DOOR FAILS TO OPEN
In case of a power failure or an emergency situation, proceed as follows:
1. Before the door is open, check the washing bath and machine parts temperature.
! WARNING !
IF TOO HOT DO NOT OPEN! RISK OF BURN OR SCALD INJURIES ! KEEP CHILDREN OFF WHEN THE MACHINE IS IN OPERATION !
2.When the washing bath is cooled down, find the lever of emergency door opening on the left bottom side pull the lever by a screwdriver (∅ 4 mm / 0.15“) to open the door.
! WARNING !
IF THE WASHING WATER WAS NOT DRAINED OFF, IT WILL RUN OUT THROUGH THE DOOR OPENING !
26 | INSTALLATION AND MAINTENANCE MANUAL | PUBLICATION DATE Sep 05 100646 |
