Remove and Replace Refrigerator Doors and Drawer Front
Depending on the width of your door opening, it may be necessary to remove the refrigerator doors to move the refrigerator into your home.
Remove Doors and Hinges
IMPORTANT:
■If the refrigerator was previously installed and you are moving it out of the home, before you begin, turn the refrigerator control OFF, and unplug the refrigerator or disconnect power. Remove food and any adjustable door or utility bins from doors.
■Keep the refrigerator doors closed until you are ready to lift them free from the cabinet. Provide additional support for the refrigerator door while the hinges are being removed. Do not depend on the door gasket magnets to hold the door in place while you are working.
■All graphics referenced in the following instructions are included later in this section after “Final Steps.”
TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", and ¹⁄₄" hex head socket wrenches, Torx®† T27 screwdriver, #2 Phillips screwdriver, and a
Replace Doors and Hinges
1.Replace the parts for the bottom hinge as shown in Bottom Hinge graphic. Tighten screws. Replace the refrigerator door.
NOTE: Provide additional support for the refrigerator door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working.
2.Assemble the parts for the top hinges as shown in Top Hinge graphic. Do not tighten the screws completely.
External Dispenser Models Only:
■Reconnect the wiring plug on top of the
■Reconnect the water line by pulling back the locking collar ring while firmly pushing the water line into the connector. Check for leaks.
3.Align the door so that the bottom of the refrigerator door aligns evenly with the top of the freezer drawer. Tighten all screws.
4.Replace the top hinge covers.
Remove Doors and Hinges
1.Unplug refrigerator or disconnect power.
2.Remove the base grille. Grasp the grille firmly and pull it toward you.
3.Starting with the
4.Remove the hinge pin cover from the bottom hinge pin and keep it for later use. See Bottom Hinge graphic.
5.Remove top hinge cover from the
External Dispenser Models Only:
■Disconnect the wiring plug, located under the top left- hand side door hinge, by wedging a
■Disconnect the water line, located under the top
6.Lift the
NOTE: On some models, remove the hinge pin cover from the bottom hinge pin and keep it for later use. See Bottom Hinge graphic.
Remove and Replace Freezer Drawer Front
IMPORTANT: Two people may be required to remove and replace the freezer drawer. Graphics are included later in this section.
Remove Drawer Front
1.Open the freezer drawer to full extension.
2.Loosen the four screws attaching the drawer glides to the drawer front. See Drawer Front Removal graphic.
NOTE: Loosen screws three to four turns. Keep the screws in the drawer front.
3.Lift drawer front upward and off the screws. See Drawer Front Removal graphic.
4.The refrigerator leveling/roller assembly protrudes from each side of the cabinet base. Remove the three screws attaching each assembly, and remove the assemblies. See Refrigerator Leveling/Roller Assembly graphic.
†®TORX is a registered trademark of Saturn Fasteners, Inc.
4