2
TO INSTALL BAGGER FULL LEVER/PADDLE
•Before installation, tractor engine must be shut off and parking brake engaged.
•Standing behind the tractor with the bagger removed from the backplate (1), identify the bag full switch (2) area. (See Fig 1)
2 |
|
|
|
|
1 |
|
|
|
|
Fig. 1 |
|
|
|
|
FRONT OF TRACTOR |
|
|
| 4 |
| 4 |
| 5 |
|
|
|
| 3 | |
3 |
|
|
| |
|
|
|
| |
| 2 | 7 |
|
|
|
| 6 | 8 | |
Fig. 2 |
| Fig. 3 | ||
|
|
|
•Take bagger full lever (3) and insert tab(4) into upper slot and rotate until lever (3) snaps into position (See Figs. 2 and 3)
•For the heaviest/wet grasses, do not attach paddle (5).
•For lighter grasses use the paddle (5) on setting “1”, “2”, or “3” (“3” being for the lightest or dry grass).
•Choose your setting and rotate the bagger paddle (5) so that the desired number (setting) faces you.
•Place paddle (5) on lever (3) so that tab (6) at the bottom of the bagger full lever (3) goes through appropriate rectangular slot and make sure holes in bagger full lever (3) and paddle
(5) line up.
•Feed screw (7) through bagger full paddle (5) and lever (3) holes and fasten using nut (8) (See Fig. 3)
•Setting may be changed by loosening fasteners (7 and 8), removing/rotating paddle (5), and tightening again.
TO INSTALL BAGGER COMPONENT TO TRACTOR
1 | 3 |
2 | 1 |
|
•Before installation, tractor engine must be shut off and parking brake engaged.
•Install latch springs (1) in mounting holes on back plate.
•Insert hex bolt (2) through each latch spring hole and corresponding hole in back plate.
•Fasten lock nut (3) to bolt on the other side of back plate.
27
