McDATA 4416 Mount the Switch Module in the Server Chassis, Module Slot, Switch Module in I/O

Installing a Switch

Mount the Switch Module in the Server Chassis

McDATA 4416 switch modules are installed in server chassis I/O module slots 3 and 4 as shown in Figure 3-1. For a single switch module installation, use I/O module slot 3. Do not attempt to install the McDATA 4416 switch module in any other I/O module slots.

Switch Module in

I/O Module Slot 3

Switch Module in I/O

Module Slot 4

Figure 3-1. Mounting the Switch Module in the Server Chassis

To insert the McDATA 4416 switch module, do the following:

1.Verify that chassis I/O module slots 3 and 4 are empty.

2.Gripping from the top and bottom of the release latch, gently squeeze the latch to free the insertion arm.

3.Swing the insertion arm out (away from the chassis) until it is completely open.

4.Slide the switch module into the open I/O module slot.

5.Push the insertion arm gently toward the chassis until it is completely closed and the switch module is firmly seated.

CAUTION

Do not force the arm closed. Doing so could cause damage. Instead, if the switch module does not close easily, gently remove the switch module and reinsert it.

Installation

3-3