Setup
How to Operate the Setup Modes
Your McIntosh C220 has been factory configured for default operating settings that will allow immediate enjoy- ment of superb audio without the need for further adjust- ments. If you wish to make changes to the factory default settings, a Setup Feature is provided to customize the oper- ating settings using the Front Panel Alphanumeric Display.
1.Press the STANDBY/ON
Note: The Red LED above the STANDBY/ON
2.Press the C220 Front Panel SETUP
Note: The Front Panel Display will indicate C220 V1.00 or higher the first time, after that it will dis- play whatever Setup Mode was last accessed.
Figure 1
3.Press Menu (MONO)
4.Press Menu (TONE BYPASS)
5.To exit from a specific Setup Mode, press the SETUP
Default Settings
Function Name | Setting | Page No. |
|
|
|
REMOTE | NORMal | 13 |
TUBE LED | ON | 13 |
AUTOTONE | ON | 13 |
ACCessory < C > | MAIN | 13 |
TRIGger | TUNER > | 13 |
DISPLAY | 7 | 12 |
INPut | TUNer > TUNer | 12 |
TRIM | 0.0 TUNner | 11 |
BALANCE | 00 | 16 |
C220 | V_._ _ | 11 |
Firmware Version
The C220 functionality is controlled by internal software that is know as Firmware. The Version of the Firmware in the C220 can be identified at any time by utilizing the Setup Mode.
1.Press the SETUP
2.Press the Menu or Menu
3.The number after the character “V” is the Firmware number.
4.Press the SETUP
Balance
For information on using the Balance adjustment, refer to “How to Operate, Balance (Trim Function)” on page 16.
Figure 2
Default Settings
The Default Settings Chart at the top of the page (right column) indicate the Function Name, default Settings and the page number for instructions on how to change it.
Trim Level Adjustment
Source Components can have slightly different volume levels resulting in the need to readjust the C220 Volume Control when switching between different sources. The C220 allows the adjustment of levels for each of the Source Inputs for the same relative volume. The Tuner and CD Inputs are used in the following example.
Note: The range of adjustment is ± 6dB. The Tape/Record Output Levels are unaffected by any changes in the Level Trim Settings. The Trim adjustments made are retained in permanent memory. They can be changed by performing a new Trim Procedure. The Tuner Input Volume Level can serve as a reference or choose an- other source frequently listened to. The reference Input Source should be set to a Trim Level of 00.
11