Setup, con’t
3. Press the TRIM LEVEL Down |
| Auto Tone | |||
Front Panel Alphanumeric Display indicates “Display |
|
|
| ||
| The C220 remembers for each input if the TONE BYPASS | ||||
3”. |
| ||||
| has been activated. To | ||||
4. Press the SETUP |
| ||||
| ture, perform the following: | ||||
|
|
| 1. Press the SETUP | ||
Power Control Triggers |
| Mode. | |||
|
|
| 2. Press the Menu or Menu | ||
|
| ||||
The SPKR1(A) and SPKR2(B) Power Control Outputs are | |||||
| “AUTOTONE ON” appears on the Front Panel Alpha- | ||||
reassignable to activate only when a given Input is select- |
| ||||
| numeric Display. | ||||
ed. In the following example, the Power Control SPKR1(A) |
| ||||
| 3. Press the SELECT or | ||||
Jack will be set to function as TRIGGER A for the DVD |
| ||||
| play indicates “AUTOTONE OFF”. | ||||
Input. |
| ||||
| 4. Press the SETUP | ||||
1. Press the SETUP |
| ||||
|
|
| |||
Mode. |
| Tube LED | |||
2. Press the Menu Menu or Menu |
| ||||
“TRIG TUN > - - ” appears on the Front Panel Alpha- |
| To swich Off the Tube LED green illumination perform the | |||
numeric Display. |
| following: | |||
3. Rotate the INPUT Control until the display indicates |
| 1. Press the SETUP | |||
“TRIG DVD > - - ”. Refer to figure 7. |
| Mode. | |||
|
|
| 2. Press the Menu or Menu | ||
|
|
| |||
|
|
| “TUBE LED ON” appears on the Front Panel Alphanu- | ||
|
|
| meric Display. | ||
| Figure 7 |
| 3. Press the SELECT or | ||
4. Press the SELECT or |
| play indicates “TUBE LED OFF”. | |||
play indicates “TRIG DVD > A ”. Refer to figure 8. |
| 4. Press the SETUP |
Figure 8
5. Press the SETUP
Accessory Power Control
The ACC (C) Power Control Output is reassignable from going ON/OFF with the C220 (Main), to be controlled by the Remote Control ACC ON/OFF
1.Press the SETUP
2.Press the Menu or Menu
3.Press the SELECT or
Figure 9
4. Press the SETUP
Remote Control Selection
The C220 will respond to Remote Control Codes NORMal (default) or ALTernate. The ALTernate Codes are for use when the C220 is part of a system with another McIntosh Control Center or Preamplifier. This will prevent the Re- mote Control from affecting the operation of both units at the same time.
Note: If the ALT Remote Control Code is selected, the C220 will not respond using the supplied McIntosh Remote Control. See your McIntosh Dealer for additional information.
1.Press the SETUP
2.Press the Menu or Menu
3.Press the SELECT or
4.Press the SETUP
13