How to use the Remote Control
The supplied Remote Control is capable of directly con- trolling the functions of contemporary McIntosh Source Components connected to the C220 Tube Preamplifier. Earlier McIntosh source components and other brand source components can be controlled by the C220 Remote Control with the addition of a McIntosh Remote Control Translator (RCT).
Note: Your McIntosh Dealer can assist you with the instal- lation and operation of the Remote Control Translator (RCT).
Input Source Selection
Press the appropriate Source Push-button to select the desired program source.
Mute
Press the MUTE Push-button to mute audio. The Record Signals present at the TAPE OUTPUT Jack are not affect- ed by the MUTE function. The C220 Front Panel Alphanu- meric Display will indicate the word MUTE. Press MUTE a second time to unmute audio.
Mode
Press the MODE Push-button to switch from Stereo to Mono for Monophonic listening.
Disc, Server and Tape Functions
Use these push-buttons to operate a DVD Player, CD Player, CD Changer, Music Server or Tape Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre- sets, tracks on discs or selections on a Music Server.
Disc and Track
Use the DISC and TRACK Push-buttons when a Disc Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired broadcast band. Press and release the CHANnel Up or Down Push-button to move from station to station. Press and hold a CHANnel Up or Down Push-button to move continuously from station to station. Press the +10 Push-button to start the automatic brief audition of each of the presets stored in the tuner memory. Press +10 Push- button a second time to stop on a station preset.
Volume
Press the Up or Down VOLUME Push-button to raise or lower the listening volume level.
Note: The Record Signals present at TAPE OUTPUTS are not affected by volume changes.
Pause
Press Pause 
Pushbutton to perform various functions on a variety of McIntosh Components. It will also pause the playing of a disc or tape player. The Pause 
Push-but- ton will also allow for quick exiting from the active menu when in the setup mode. The Pause
Push-button is also used as an Enter Push-button with some McIntosh compo- nents.
Trim
Press the TRIM Push-button until the word “BALANCE” appears on the Alphanumeric display, then press the LEVEL Up Push-button to emphasize the Left Channel or Down Push-button to emphasize the Right Channel.
Press the TRIM Push-button until the word “TRIM _
__ _ _” appears on the Alphanumeric display, then press the LEVEL Up or Down Push-button to match the volume level of the previously selected Input.
Notes: 1. Refer to “Balance Control (Trim Function)” on page 16 for additional information.
2.Refer to “Trim Level Adjustment” on page 11 for additional information.
Acc On
Press ACC ON to turn the power ON to a McIntosh Disc Player.
Acc Off
Press ACC OFF to turn the power OFF to a McIntosh Disc Player.
Amplifier Selection
Press the 2nd Push-button followed by the OUTPUT 1 or 2 Push-buttons either separately or together, to control the rear panel OUTPUTS 1, 2 which can feed signals to a Power Amplifier or other accessory component.
