Stand Assembly Instructions
To assemble the Stand supplied with the Trap, follow the instructions shown in figure 2 below.
Fix external skirt then tip the Trap on its side and slide onto hook.
Wind direction
Fit top section over bottom section of upright - then fit bolt and tighten firmly
FIG 2 - Trap Assembly Instructions
Assemble stand base components as illustrated here - fit all bolts and washers before tightening bolts firmly. Screw feet into bottom of stand base.
3 x 4" Wire staples are supplied to secure frame to ground.
NOTE: For optimum performance place the trap in a predominantly shaded area (located between your dwelling and the source of the mosquitoes) which is protected from rain and wind. (Mosquitoes do not fly in strong winds or severe weather conditions.)
For maximum stability the 'U' shaped leg at the back of the stand should be pointed in the direction of prevailing winds. The wire staples supplied with the trap (or a cinder block placed on the back of the stand) can be used to increase stability.
7
