What to do when these messages are displayed
Message | Cause (Details) |
No Signal DVI-D
No device is connected to the DVI terminal.
The terminal is connected but there is no signal output.
[Input the video signals.
1000h
EXIT
When lamp time reaches 1000 hours
[A message indicating “1000 h” will be displayed on the screen.
● Press the [EXIT] button to clear the display.
Lamp replacement
EXIT
At the moment when the accumulated lamp time reaches 1900 hours, a “Lamp replacement” message will be displayed. In addition, when the accumulated lamp time reaches between 1900 hours to 2000 hours, the “Lamp replacement” message will be displayed each time the projector is turned on.
●The message can be cleared by pressing the [EXIT] button or displaying the menu.
[Get ready a new lamp (lamp unit) in advance or replace as soon as possible.
Lamp replacement
Warning
EXIT
The “Warning” word appears and blinks when the accumulated lamp time exceeds 2000 hours.
The message can be cleared by pressing the [EXIT] button. However, the same message will reappear every hour. When the accumulated lamp time exceeds 2000 hours, the unit cannot be turned on again once it is turned off.
If continuous projection is performed after 2000 hours, the unit will shut down upon exceeding 2010 hours and projection will be disabled.
[Install a new lamp (lamp unit) and reset the lamp time. (☞ Pages 28 - 30)
32
